Bumper Cutting?
Thread Starter
On The Tree
Joined: May 2004
Posts: 197
Likes: 0
Bumper Cutting? Hey guys,
Got a license plate frame i'd like to put on the rear, but it sticks up a little too far to fit. I need to cut up into the bumper so that it fits.
What would you recommend I use to do this? I'm pretty worried about smoothing it out afterwards, even though it's not visible. There's already a small gap there, so i'd just need to widen that to the edges of the license plate area and it only needs to be wide enough to fit the thickness of the frame (maybe a 1/4 inch?).
Suggestions before I screw something up?
Got a license plate frame i'd like to put on the rear, but it sticks up a little too far to fit. I need to cut up into the bumper so that it fits.
What would you recommend I use to do this? I'm pretty worried about smoothing it out afterwards, even though it's not visible. There's already a small gap there, so i'd just need to widen that to the edges of the license plate area and it only needs to be wide enough to fit the thickness of the frame (maybe a 1/4 inch?).
Suggestions before I screw something up?
