M6 console mods?
l;ike where u can see the line going 1-2-3-4? theres no boot at all just a metal piece that your shifter is perpendicular with? if im thinking right, that would look pretty cool, but id want someone to do it before me lol
Trending Topics
I think it would make it a little easier. 1, you can actually see where the shifter it going and 2. its cool and different. I would really love to see it actually on a car with like a ripper shifter or something like that 
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
i think it would make shifting HARDER big because you have such a small grove to get your shifter into and think about it when you put your shifter in gear there is still some play side to side. mine shakes when i drive...metal to metal would be annoying(sp). imo
i love the look tho
i love the look tho
you would also have to have a fairly small diameter shifter stick, if its thick like the UMI short stick that I have, the guides would have to be kind of wide. Im sure this would still be do-able but just something else to think about
Originally Posted by CamaroSS621
I think it would make it a little easier. 1, you can actually see where the shifter it going
i had thought about this before also. the first step would be making a cardboard template and bolting it in. one problem is, how are you going to seal off the underside of teh center console and the top? the leather boot takes care of that right now, but what would u do with this idea?
ive thought about this since i owned my fiero cause those kits were all over the place.i always thought id be nice in my ta as well but as far as making one i think youd have to refab a whole new upper m6 console(ls1 style)you know,the part thast hold the shift boot and unbolts from inside.you could replicate it in fiberglass then bondo in what youd want the new peice to be like.then replicate that prototype and finish it.But i think itd look outa place unless you did it in brushed aluminum then purchasedf a brushed aluminum accent kit for the dash or something similar.It could deffinately be done though thats for sure.
Originally Posted by Phoenix 5.7
i had thought about this before also. the first step would be making a cardboard template and bolting it in. one problem is, how are you going to seal off the underside of teh center console and the top? the leather boot takes care of that right now, but what would u do with this idea?
Almost ..Id use acryllic plastic...
i think that would be tough to shift because the you'd have a dual-gated shifter. if there were no internal gates, then sure, but i'd like to see someone powershift that w/o bending or breaking it (acrylic)....if it's anything other than cosmetic.