how do i put emblems back on
Thread Starter
Teching In
Joined: Feb 2006
Posts: 8
Likes: 0
how do i put emblems back on i took the ss and chevy bow tie off the back of my car cause im trying make my own berger panel using the instructions i got from these forums so my question is how would i put them back on after im done? what type of adhesive am i suppose to use?
TECH Fanatic
Joined: Jun 2004
Posts: 1,535
Likes: 1
From: The Houndstooth
Originally Posted by nhra-trans-am
3m emblem tape
Get some 3M double sided automotive tape. Peel one side back and apply it to the back of your emblem. Trim the excess with a razor/box cutter. Then peel off the other side and stick it on.Be sure the spot is clean. Rubbing alcohol works well.
if that doesn't work... duct tape it
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'
Brett Foote
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
