How to put SS emblem on Grill?
How to put SS emblem on Grill? So I got my billet grill and my 69' SS emblem but I have no clue how to put the emblem on the Grill. 
What's the correct way or simple way of making this work? I dont want to damage this and I want it to look good. Any feedback is appreciated.Thanx!
What's the correct way or simple way of making this work? I dont want to damage this and I want it to look good. Any feedback is appreciated.Thanx! they sell an epoxy at autozone or whatever auto place, it works on everything from metal to fiberglass, wood, and plastic. Its a 2 conister deal with a plunger (like a syringe) and it comes with a mixing tube attachment for the end (mixer is about 3 inches long) that should do it.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
I am going the same way with the braket that was supplied with some self threading nuts and then gring off the numbs. You also have to cut the bracket in half, so I have been told.
TECH Apprentice
Joined: Jul 2006
Posts: 315
Likes: 0
From: MASS
this is about the 5th time ive seen a post like this..lol, but here goes. the emblem must be heated and bent but you have to do it very carefully and not too much at a time be cause it will crack....once you have it fit perfectly to the angle of the grille, center it and get it right to where you want it. cut the rectangle washer enough so it will hold between the lines of the grille but not too much as to where you can visually see it when looking at the car. use self tapping nuts, i used orig gm ones and they worked perfect, you could get that at any junkyard off of an old emblem or side markers usually have them as well. thread them on nice and tight and cut the excess studs off so it will fit snugly against the bumper....this is how ive done a few and it works perfect....you could use jb weld or some sort of adhesive as well, im sure it would work i just dont like those ways....hope this helps
Originally Posted by The old man
H'mmmmmm Grind the pegs off the back.... Use 3M tape to mount it...
NO!!! use a drimmel and cut into the grill. and use the supplied brakets to mountit on the grille
