Camaro with Tips please..
#23
Originally Posted by camar0corey
What I used to have, slant cut tips, that were angled:
I fixed the one sides hanger later on so they sat more even.
I fixed the one sides hanger later on so they sat more even.
dude that looks like puke on there , but i guess it is your car
#27
On The Tree
Join Date: Aug 2006
Location: Lexington, NC
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
No doubt, a lot of beautiful Camaro's with tips in this thread. However, I've never been a fan of tips. That's just my opinion. I'm all 3" custom dual setup with 3" turndowns dumped.
I get compliments all the time. Anyway, good luck with your choice!
turndowns are nice.. but you dont get the look while you are driving.. only people can see if they look under the car or if your car is on the lift.
#28
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Oct 2006
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Jlo's 96 Z28SS
No doubt, a lot of beautiful Camaro's with tips in this thread. However, I've never been a fan of tips. That's just my opinion. I'm all 3" custom dual setup with 3" turndowns dumped.
I get compliments all the time. Anyway, good luck with your choice!
I get compliments all the time. Anyway, good luck with your choice!
Looks nice.. But do they hang too low?
My true duals hug up on the car soo much higher. Although, I did have to minipulate the floorboards some. But it was well worth it.
Anyways, your car looks great!
#30
On The Tree
Join Date: Aug 2006
Location: Lexington, NC
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
Not trying to steal your thread SsycoticSS, just answering Blknight6989. I run Mickey Thompson ET Street Radials(315's). You can go to the "Wheels & Tires" section and under "Pics of 315's in the rear!" A lot of guys have them now.
#33
TECH Fanatic
iTrader: (10)
Join Date: Aug 2002
Location: Danville,PA
Posts: 1,110
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by camar0corey
Ah! I'm pissed to learn about Meg's tips....... When I was looking for tips to finish off my exhaust revamp no one could fine me a 3" inlet that was a dual outlet tip that was slant cut...... What do you know they have one......
Here is mine with a hooker slant cut dual tip, sucks though I had to have the 2.5" inlet made to 3" and there is a restriction at the middle of the tip then.
Here is mine with a hooker slant cut dual tip, sucks though I had to have the 2.5" inlet made to 3" and there is a restriction at the middle of the tip then.