chrysler kid

iTrader: (14)

Love the car! What wheels are those?

ZexGX

iTrader: (28)

X2, interested in the wheels.

BRDMAN

iTrader: (8)

Damm, I love the look......

Mr. Trick

iTrader: (19)

That looks real good. Someone should produce a spoiler like that ready to bolt on a ta/firebird.

Raleigh TA

iTrader: (13)

Op only comes here every 4 yrs, it may be a while before you get that answer...

CW00BlackTA

iTrader: (31)

It is dropped!

I know, I'd like it a bit lower too but that causes all kinds of trouble that's just not worth the effort (tires rub, exhaust scrapes, 9 inch bangs the floor, etc.).

CW00BlackTA

iTrader: (31)

D-Force... What I liked about them besides the looks is the weight--saved about 10 lbs. off each corner. These are made for BMWs so check out the BMW Wheels thread. These fit fine and have worked fine so far (ran 'em up to 145). Also never seen them on an F-body before either, although they are probably out there.

LTW5
Size Weight
15x7 13.0 lbs
17x8 15.5 lbs
17x8.5 16.2 lbs
17x9 16.4 lbs

18x9 17.8 lbs
18x9.5 18.4 lbs
18x10 18.8 lbs

CW00BlackTA

iTrader: (31)

Hey! I'm doing pretty good eh?

Thanks for the compliments everyone.

hotrodT/A

Its different if thats what your going for. But personally im a fan of the huge stock spoiler of the t/a its a drfining point of the car

CW00BlackTA

iTrader: (31)

Funny story about the wheels. If you buy these, don't tell the Discout Tire guys they are for an F-body or they won't mount them. They knew I had Pontiac and when I took the wheels and tires in they asked what they were going on! The guy at the desk asked if these were going on my Bonneville. LOL Then two different guys in the shop were asking me what they were for--and wouldn't drop it. I finally told them they were for my 2003 M3 (which I've never owned). Then they lectured me about some people trying to run these on GTOs. It was almost as bad as when Pep Boys refused to put a set of half inch taller tires on my wife's minivan--because it's not the factory size!!!

CW00BlackTA

iTrader: (31)

Bingo! I like the stock too, just not as well. I always liked the rear end of Camaros better and the front end of the TAs. The Heritage TA is what gave me the idea to do this. It all comes down to taste. We're just lucky we don't all have the exact same thing or this site would be really boring.

stevesfbody

just curious but what's the cost per wheel on your car if you don't mind me asking?

CW00BlackTA

iTrader: (31)

The whole set was about $1300 delivered.

Spread Eagle WS6

iTrader: (2)

does not look half bad