hey guys,I bought a used yank ss3600.brand new in box for a great deal.$470,but I have a few questions.the part # on the box says ss36000ls2.on the converter its written 3600 in permanent marker.

1.on the converter it says 3600ls1/04/07.what are the later numbers 04/07,manufacture date?
2.converter seems heavy.lighter or heavier than stock?

pics are attached.what else needs to be done to run effectively.thanks hopefully its the right one that way I can make the S.I list

 

ooops just read sticky looks like I will need tranny cooler,and aftermarket torque converters are lighter than stock

 

damn, that should put you in the 11's.

 

so was it a mistake on the box part#?Is it the right stall for a ls1
what does 04/07 mean
someone with a yank conv has to know

 

probally the date mine was a 05/08

 

sweet atver300 thanks alot,looks to be the right on then,just a mistake on the box

 

Must be common. My PT4000 came in a box that was marked for an LS2. In the end it really doesn't matter.

 

You should be fine. Go put that baby in. While your in there you may want to put in a new input shaft seal. Only costed me $1.62 at Napa with my discount. And don't worry the bolts that came with the converter and perfect sized, if your running the stock flexplate. (They look a little small), good luck - Zack

 

1/04/07 is date built it is a SS3600 for the LS type of 4L60E transmission

Sounds like a great deal
Good luck with you project

 

thank you sir, its just a bolton ls1 with a 100shot looking to go 10's