LS-1<>57

iTrader: (3)

I picked up a brand new 4l65E, with stock converter, bought from the factory in 2006 with zero miles.....never had a bell housing bolt in it. Got a great deal and am looking for thoughts on adding a shift kit or upgrading the converter. I wont be racing my car, but will def see plenty of WOT time and occaisional holeshots. I have 30 inch tall by 12 inch wide Mickeys on the back with a 4.11 gear. I dont want to spend alot of money un-necessarily, but dont want to see problems cause I plan to drive alot.

Any thoughts or advice from you trans experts appreciated.!!
Thanx DK

performabuilt

iTrader: (25)

I would go with the transgo hd2 kit and at least install the beast sunshell while I was in there

LS-1<>57

iTrader: (3)

Thanx for the advice..!! I have installed the Transgo HD2 in my 4l60e so i know how to do that. Isn't that a total teardown to install the beast sunshell...?

Thanx again....DK

Bret@EFIAlchemy

iTrader: (3)

Its not a total teardown, youll have to pull the pan, pump, input housing w drum, 2-4 band, snap ring and top planetary assy.

BlownVette 2001

iTrader: (2)

Nice ride, but I would scrap those Corvette covers on the engine and do some aluminium valve covers along with relocating the coil packs.

performabuilt

iTrader: (25)

Yes you wont be far if your installing the TG 3-4 springs just a clip and a couple parts further down