Hey guys, got the TH400 installed (fourth gen camaro), and I'm attempting to swap the shifter for a B & M Hammer. I got the shifter select cable removed from the driver's side of the shifter, but on the passenger side of the shifter there is a second cable.

Anyone know what this cable is and where it goes to?



I tried finding it underneath the car and I can't tell where this cable is!

Thanks again for any help/advice!

 

If I am not mistaken the second cable is the shifter lock , When the switch is off it will not allow the shifter to move.

 

Ok cool, thanks...now if this cable doesn't go to the transmission, where does it route to?

 

to the steering columb I beleave

 

NO WONDER I couldn't find it underneath the car then. lol
I assume that cable stays inside the passenger compartment then?

 

Yes that would be correct

 

ok dumb question i am in same boat..

just did m6 -a4 swap i bolted down teh shifter attached the cabel the goes to the tranny..and tis 2nd cable where does it plug into the column at?? trying to get a location idea..

im guessing that is the reason why my shifter wont move..