question breaking tail housings
Thread Starter
Registered User
Joined: Apr 2009
Posts: 2
Likes: 0
question breaking tail housings I got a 98 Camaro z with the 4l60e I kept blowing
The seal and bushing out of the tail housing then the tail housing
Broke bout a Week ago and then It Broke Again yesterday what could this b? Any help would b great
The seal and bushing out of the tail housing then the tail housing
Broke bout a Week ago and then It Broke Again yesterday what could this b? Any help would b great
Steel driveshaft? Maybe with higher than factory
gearing? Any aftermarket suspension mods that
might have wanted driveline angle trued up?
Guessing is a lot more fun when we don't have
to guess blind. Putting mods in your signature
provides useful clues.
gearing? Any aftermarket suspension mods that
might have wanted driveline angle trued up?
Guessing is a lot more fun when we don't have
to guess blind. Putting mods in your signature
provides useful clues.
You should get an aluminum driveshaft out of the
junkyard, the steel one isn't good to overspin. It
was only put on 2.73 cars for a reason. When it
starts to bow and whip, it takes out tailhousings
and the occasional pinion yoke too.
junkyard, the steel one isn't good to overspin. It
was only put on 2.73 cars for a reason. When it
starts to bow and whip, it takes out tailhousings
and the occasional pinion yoke too.
