flywheel?
Thread Starter
TECH Fanatic
iTrader: (-1)
Joined: Nov 2002
Posts: 1,178
Likes: 0
From: Southeast Texas
flywheel? i think i might have bent my flywheel a little bit but cant really tell... if so, if i get it resurfaced, will they check and see if its bent? and who can resurface them?? and about how much will it cost? thanks
TECH Enthusiast
Joined: Nov 2001
Posts: 521
Likes: 0
From: Farmingdale NJ
There is no resurfacing a flexplate (automatics have flexplates, sticks have flywheels).
The only way to check if it's bent is with a dial indicator (unless it's seriously bent). There is a tolerance there, but it's not much. I'm sorry but I don't know what it is off the top of my head.
What is it that is making you think the flexplate is bent? Symptom? Installation accident?
The only way to check if it's bent is with a dial indicator (unless it's seriously bent). There is a tolerance there, but it's not much. I'm sorry but I don't know what it is off the top of my head.
What is it that is making you think the flexplate is bent? Symptom? Installation accident?
Thread Starter
TECH Fanatic
iTrader: (-1)
Joined: Nov 2002
Posts: 1,178
Likes: 0
From: Southeast Texas
i took my motor out and didnt take the crank pully off, and i took the bar from my jack and tried to hold the flexplate while we broke the bolt loose, and it might have bent just a little bit
