anyone ???????????
Thread Starter
11 Second Club
Joined: Aug 2003
Posts: 220
Likes: 0
From: Brew City
Has anyone just rebuilt the 3/4 clutch pack only --or do you have to rebiuld the entire trans ?
Has anyone just rebuilt the 3/4 clutch pack only --or do you have to rebiuld the entire trans ?
Has anyone just rebuilt the 3/4 clutch pack only --or do you have to rebiuld the entire trans ?
Last edited by Ragtop 99; Dec 28, 2003 at 08:49 PM.
Thread Starter
11 Second Club
Joined: Aug 2003
Posts: 220
Likes: 0
From: Brew City
I guess you need to soak the clutches for a 1/2 hour or so before you install them
otherwise they burn up real fast
Now the 3/4 is the clutches at the back end of the drum with the input shaft --?????
god dont tell me its the front ones
otherwise they burn up real fast
Now the 3/4 is the clutches at the back end of the drum with the input shaft --?????
god dont tell me its the front ones
TECH Enthusiast
Joined: Nov 2001
Posts: 521
Likes: 0
From: Farmingdale NJ
Yep, thems the ones! Right in the back of the input housing. They're a pretty simple repair as far as internal work goes. Make sure before you soak the plates in ATF you check your clearances. Once you soak them you'll never be able to accurately determine freeplay.
The question posted by Grape Ape was can you just replace the 3/4 clutch pack.
Do to a software glitch,
the post may have been messed up in doing maintenance.
My apologies.
Do to a software glitch,
the post may have been messed up in doing maintenance. My apologies.
