is there a bearing or bushing or something in the tailshaft that can wear out bc my driveshaft has a lot of play in it when u shake it up and down in and it has a vibration in it when u get to about 40mph or higher. if so how much and how hard is it to replace

 

yes, but it depends on what your 4L60 is in. Year model, pictures etc..

here is an example of a kit

 

Yeah, its a bushing. You would need to remove the tailshaft, press the old one out, new one in, and replace the tailshaft. I have done them on the t56s before.

 

its a 99 camaro, and iv replace u joints and trans mount and its still there and it seems like its getting worse. iv heard that its suppose to have a little play where the drive shaft goes into the tailshaft but it just seems i have to much

 

How many miles on the tranny?

Has the Tranny been rebuilt before ??

You might have issues with the bushings been worn in the tranny, or other internal problems that is creating that extra play.

 

the trans is a performabuilt trans that has about 3000 miles on it but i had to use my old tail shaft witch has 147,000 on it

 

Did you not install these when you received your new transmission from them? I'm pretty sure that they should have been shipped with your trans.

 

i had some of the same problem and it was n the tail shaft well thats what they say fixed it

 

no they didnt send them but to be honest i didnt think i needed them lol. where can i get them from and whats the symptoms of a bad drive shaft such as one being twisted or something