daddyoisback

iTrader: (6)

doing a v6(2002) swap to a LT1(97) I got a 4l60e i believe it's a 94' but either i or the guy i got it from broke the torque arm mount and it cracked a chunck of the tailshaft. My question is if I go with a aftermarket trans torquearm mount crossmember can I just use ant 4l60e tailshaft? like from a truck or s10 etc needs to b the 4 bolt one. so part of the question would b the drive shaft too fitting in the tailshaft.

01ssreda4

iTrader: (96)

If you go with a relocation crossmember then a truck tail would work fine. I'm running that setup.

daddyoisback

iTrader: (6)

great ty for the reply just gotta figure out who i'm going with so many companys now. Thinking MWC iv'e had sphon,bmr,even Paxton before they went Granatelli