4l80 and BMR crossmember alignment issues
Thread Starter
Staging Lane
Joined: Mar 2014
Posts: 95
Likes: 0
4l80 and BMR crossmember alignment issues I've got an issue. I know there is nothing wrong with the crossmember that I purchased because I had it checked with BMR. The tranny mount holes, or should I say the center hole is not lining up with the crossmember. I would post pictures but I'm doing this with my phone. I need some advice on what to do to line it up. I'm using the UMI solid motor mounts so I know they won't budge much and the transmission is sitting more over to the passenger side. What the heck happened there? I've never had this issue swapping trannies.
I reamed mine out a tad bit, but shouldn't take much. Its very easy to slide the k member.
I've got an issue. I know there is nothing wrong with the crossmember that I purchased because I had it checked with BMR. The tranny mount holes, or should I say the center hole is not lining up with the crossmember. I would post pictures but I'm doing this with my phone. I need some advice on what to do to line it up. I'm using the UMI solid motor mounts so I know they won't budge much and the transmission is sitting more over to the passenger side. What the heck happened there? I've never had this issue swapping trannies.
__________________
Glenn ***
Sales Tech
www.bmrsuspension.com
813.986.9302
Find a Quality alignment shop near you!
Glenn ***
Sales Tech
www.bmrsuspension.com
813.986.9302
Find a Quality alignment shop near you!
Don’t mean to bump an old thread, but I’m going through hell with this same exact issue. The tail shaft is kicked so far over to the passenger side that the pass. side header is hitting the under body and the trans mount won’t line up to bolt it onto the crossmember...
