who makes a driveshaft for an m6 to th400 conversion?
who makes a driveshaft for an m6 to th400 conversion? just like the topic says...
I have a moser 12 bolt in the car as well
I'd rather just buy one complete as I'm running out of time to get the car done for N vs S!!!!!!!!
thanks
Conrad
I have a moser 12 bolt in the car as well
I'd rather just buy one complete as I'm running out of time to get the car done for N vs S!!!!!!!!
thanks
Conrad
The Bull
Joined: Jun 2002
Posts: 3,578
Likes: 2
From: Grand Rapids, MI
You can get them from anyone. DTS, Dynatech, etc. You just need the measurement for it. I have this at the shop. I'll get the length for you and you can get one made pretty easy locally too.
The Bull
Joined: Jun 2002
Posts: 3,578
Likes: 2
From: Grand Rapids, MI
So I measured it up. 43-3/4 For a TH400 stock location to a 12 bolt. It's 45" for a TH400 stock location to a 9". If you have adjustable LCA's this may be plus or minus a smidge. The dimensions are center of u-joint to center of u-joint. That is also using a short slip yoke.
Last edited by DERTY; Jun 3, 2004 at 01:50 PM.
