4l80 swap with 9" rear
Thread Starter
12 Second Club
Joined: Dec 2008
Posts: 319
Likes: 0
From: Richmond,VA
4l80 swap with 9" rear I will be swapping my 60 out with a 4l80 soon. I already have a moser 9" in the car along with a pst driveshaft. I've read where stock driveshaft length would work with the 4l80 just needed a different yoke. Since my driveshaft is made to fit with the 4l60 and 9" wouldn't that equal out to be about the same as a 10 bolt and stock driveshaft. I'm thinking it would work but needed some input from the guys that have done this with the existing 9" and 4l60 to 80 setup. Thanks
Miy driveshaft from the center to center is 42.5 inches and the yolk engages fairly far into the trans, MWC 9inch and 80e trans.
Best way to find out if it works is to put it in.
Best way to find out if it works is to put it in.
