Hello all!

I'm sure this has been answered but after searching I still can't find it. I'm trying to figure out If I can use the stock values in my performance upshift pressure table in hptuners. I have read to leave line pressure settings alone when you have a shift kit but since I have enabled the performance mode I'm worried that 90(stock value) across the board is too high in that table. Right now I have the table set the same as the normal shift pressure table. That being said some of my shift times at wot in performance mode seem slow to me .5 seconds. Also performance shift time setting is 0.000. Thanks for any help

btw the tranny is a flt stage 4 4L60e