2.75 turbo 400 gearset, snap ring prob.
01-02-2016, 01:09 PM
#1
2.75 turbo 400 gearset, snap ring prob. I have a 2.75 gear set, I think they were Kilgores, that I am putting in my 400
When I try and install the output shaft into the output carrier, there isn't enough space for the snap ring-I cant use any thinner bearing under the rear internal gear because it almost touching the output carrier
Do they make a thinner snap ring?
When I try and install the output shaft into the output carrier, there isn't enough space for the snap ring-I cant use any thinner bearing under the rear internal gear because it almost touching the output carrier
Do they make a thinner snap ring?
01-03-2016, 09:45 AM
#3
I think I see the problem, the snap ring slot is further down than the orig one
In the pic the "teeth" for a better word above the snap ring grove are thicker
There may well be a thinner snap ring that is supposed to go with this setup
In the pic the "teeth" for a better word above the snap ring grove are thicker
There may well be a thinner snap ring that is supposed to go with this setup