4l80e swap complete and didnt have to touch trans tunnel?
#1
Staging Lane
Thread Starter
Join Date: Apr 2015
Location: Kansas
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
4l80e swap complete and didnt have to touch trans tunnel?
i see everyone says you have to bang in the trans tunnel to even get the 80e to mount up the motor. Well i just got done with the swap and i didnt have to touch the trans tunnel.. i used a 97 4l80e out of an express van and it went into a 2000 fbody,, has this been done before or is it a fluke thing???
#5
Staging Lane
Thread Starter
Join Date: Apr 2015
Location: Kansas
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
Sorry should of been more specific... I didn't have to touch where the bell housing is. That kinda what I'm worried about because I'm getting a clunk when I hit the brakes and was curious if the bell housing is hitting the tunnel. It didn't do it at first but after 200 miles it stated doing it randomly