how to adjust shift times
Thread Starter
Joined: Nov 2001
Posts: 7,903
Likes: 1
From: Cleveland, OH
how to adjust shift times I logged my 1-2 shift on atap and noticed my shift times varied from .150 to .530 It didnt seem to be consistent as to TPS% What table do I change in ls1edit to make it quick all the time? My 2-3 shift seems ok but 1-2 is not always quick like I would like
Look for "desired shift time" or "shift adaptation time"
in the transmission tabs. Set it to something like 0.1 or
0.15 for pretty-quick, 0.0 for "impossibly quick, use full
pressure".
in the transmission tabs. Set it to something like 0.1 or
0.15 for pretty-quick, 0.0 for "impossibly quick, use full
pressure".
It made a strong difference in my car. Stock had
settings 0.15 to 0.4 sec. Predator full - put them
to 0.0s. At 0.1 it feels the same. The idea is the
PCM tries to meet those times, barely. It's the
"adaptation" process. But if it's a slow learner or
the spirit is willing but the pump is weak, maybe
you don't get what you ordered.
settings 0.15 to 0.4 sec. Predator full - put them
to 0.0s. At 0.1 it feels the same. The idea is the
PCM tries to meet those times, barely. It's the
"adaptation" process. But if it's a slow learner or
the spirit is willing but the pump is weak, maybe
you don't get what you ordered.
Thread Starter
Joined: Nov 2001
Posts: 7,903
Likes: 1
From: Cleveland, OH
it's supposed to have transgo...clutches..hardened shell etc. I'm gonna monkey with it some more tomorrow and see if i can get something to make a noticeable difference
