Help with this mod!
Thread Starter
Teching In
Joined: Jul 2005
Posts: 5
Likes: 0
Help with this mod! In an attempt to increase shift firmness i am going to increase the line pressure by following the link below.I cannot figure out how the connector comes off the solenoid.I have the car jacked up so space is limited and i am not very familiar with an A4 anyway.Thanks for any help!
http://www.ls1camaro.net/sections.ph...ticle&artid=27
http://www.ls1camaro.net/sections.ph...ticle&artid=27
12 Second Club
Joined: Sep 2002
Posts: 597
Likes: 0
From: Tampa
Its held on by a clip (I think its called an E clip???) If you're under the car, on your back, looking up at the solenoids...then you will be staring directly at the back side of the clip. Use the flat blade of a screwdriver, or needlenose pliers, to pry and pull it out.
12 Second Club
Joined: Sep 2002
Posts: 597
Likes: 0
From: Tampa
