4L60e took a dump
4L60e took a dump Recently a torque converter was installed in my Z28, The torque converter was never locked inplace and was installed. To make a long story short, the car wont go into gear. I'm positive the pump is shot. My question is what kind of pump should I buy and how hard is it to install???
dumb question but did you add any fluid to the trans after the install.. Check the level while the car is in park on level ground. Once the level looks ok, go in the car and put the shifter in each gear for 10 or so seconds, this allows fluid to fill the valve body which will lower the level of the trans fluid. Place shifter back in park and recheck the level..
this is just a guess as to your problem and i could be completely wrong.
this is just a guess as to your problem and i could be completely wrong.
