What size fitting?
06-21-2006, 10:24 AM
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: May 2006
Location: In Your Town
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
What size fitting? I want to unscrew the oil cooler line fittings from the radiator and join them together to bypass the built-in oil cooler in the radiator.
... anyone know the coupler end sizes to join the two lines together? I think it may be a 1/4"-3/8" female-to-female coupler. Does this sound right?
... anyone know the coupler end sizes to join the two lines together? I think it may be a 1/4"-3/8" female-to-female coupler. Does this sound right?
Last edited by FullBoreTA; 06-21-2006 at 01:26 PM. Reason: spelling
06-22-2006, 05:50 PM
#3
Staging Lane
Thread Starter
iTrader: (1)
Join Date: May 2006
Location: In Your Town
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
Worse-off than before the bypass. Bought the barbed fittings and used the one that worked, which was the brass 1/4" male end screwed into the brass 5/16" female end. I coupled the lines together to do the bypass ... only problem is it made my tranny temps run 15* hotter in town. Sure didn't cool it down like a lot of people said it would.
I'm re-doing it to pass back through the radiator's internal oil cooler, the way it was. Looks like I'll have to put it back the way it was.
I'm re-doing it to pass back through the radiator's internal oil cooler, the way it was. Looks like I'll have to put it back the way it was.