In the middle of a Moser 12 bolt install
#1
On The Tree
Thread Starter
iTrader: (1)
Join Date: Jan 2002
Location: ORLANDO, FL.
Posts: 101
Likes: 0
Received 0 Likes
on
0 Posts
In the middle of a Moser 12 bolt install
I'm having trouble removing the C-Clips off the ends of the existing rear end to remove the axles. I can pry the axle with a screw driver, but there is just not enough room for the c-clip to fall out. Any ideas? And by the way, I need to remove the existing axles to pull the ABS rings.
Thanks in advance
Thanks in advance
#3
On The Tree
Thread Starter
iTrader: (1)
Join Date: Jan 2002
Location: ORLANDO, FL.
Posts: 101
Likes: 0
Received 0 Likes
on
0 Posts
Re: In the middle of a Moser 12 bolt install
Yeah, I pulled the center pin and the side gears will move approximately 1/4 inch if you rotate the axle. It's the craziest thing, I replaced the ring and pinion on two other GM 10 bolts and I just pushed the each axle in and the c-clip just fell out. This time there is not enough room for the clip to fall out. Just out of curiousity, do you need to remove the emergency brake assembly/shoes?