need help with flywheel
need help with flywheel i bought a 6.0 iron block out of a 2000 2500 and are trying to put it in my 2000 trans am. i have a 4l60e and my stock flywheel seems to push up aginst the converter so hard i cant line the holes up or harldy turn the engine over.
i made sure the converter was seated and everthing. ive hade it in and out like 5 times and no go. the flexplate that came with the 6.0 fits fine but since theirs 5 or 6 holes they dont line up.
i made sure the converter was seated and everthing. ive hade it in and out like 5 times and no go. the flexplate that came with the 6.0 fits fine but since theirs 5 or 6 holes they dont line up.
no already tired to make sure the converter was seated. the stock flexplate looks like it sticks out 1/2inch to far. im guessing the mating surface the flexplate mounts to at the back of the crank is a littel farther out on the motor, can anyone varifi this. its a bone stock 6.0 vortech out of an 2000 chevy 2500.
Last edited by FRUSTRATED T/A; Jul 5, 2007 at 09:05 PM.
