so i have all 8 bellhousing bolts out, all 3 torque converter bolts out, all the sensors disconnected, the torque arm is out. I am having trouble taking the trans out. It wont budge.. we are als using a regular jack because we dont have a Trans jack. anysuggestions on getting this thing out?

 

The dowels are likly corroded to the block spray some wd40 on then let them set a while then lower the jack a little and jerk back a fourth on the trans like hell but be carefull it dosent fall on you, Been there done that and it HURTS

 

Been jingling the living hell out of it, no go at all....Still feels like something may be bolted up? All sensors out, 8 BH bolts, TC bolts out.... I'm stumped

 

She's out!!!! Just took a little bit of prying persuasion and a lot a bit of jingling!!!