has anyone use steel braided an lines for there tranny cooler if so what size fittings to fit in tranny

 

1/4 pipe to -6 male AN fitting is the ones you want to use. Be careful when installing these. Reason is that the fitting will not fully bottom out on the transmission when you tighten it down like tradition fittings. The thread pattern will work just fine with a bit of Teflon PASTE applied to the threads. I do not care for the tape for this application. Make sure that the fitting is good and snug when you tighten it down. Just make sure not to be an animal when installing these or you will break a case. Vince

 

i didnt know if it would be fesable .... i was wantin something functional and that looked good

 

It is under the car....who is going to look at it?

 

not that any one will see it but it is the fact i know it looks good .. plus the added fact if anyone does it will lmmao