Trans range switch problem, DTC P0706
06-25-2008, 10:07 AM
#1
Staging Lane
Thread Starter
Join Date: Mar 2008
Location: Stockholm, Sweden
Posts: 57
Likes: 0
Received 0 Likes
on
0 Posts
Trans range switch problem, DTC P0706 I got a DTC, P0706 from my 4L60E (LQ9 engine) but i donīt know what it means. I Have checked the lower switch on the left side of the transmisson house.
P=776 connected with 771
R=776 con. 771 + 772
N=771 con. 772
D=776 con. 772
3=772 con. 773
2=776 con. 771 + 772 + 773
1=same as above
Is this correct ? Anyone know what is wrong / Magnus
P=776 connected with 771
R=776 con. 771 + 772
N=771 con. 772
D=776 con. 772
3=772 con. 773
2=776 con. 771 + 772 + 773
1=same as above
Is this correct ? Anyone know what is wrong / Magnus
06-25-2008, 12:15 PM
#2
Have you checked the adjustment?
Conditions for Setting DTC
Condition 1
The PCM detects DRIVE or REVERSE at vehicle start-up.
Condition 2
The PCM detects PARK or NEUTRAL and the following conditions occur for 10 seconds:
The throttle position (TP) is 5 percent or greater.
Engine torque is greater than 68 N·m (50 lb ft).
The vehicle speed is 32 km/h (20 mph) or greater.
Conditions for Setting DTC
Condition 1
The PCM detects DRIVE or REVERSE at vehicle start-up.
Condition 2
The PCM detects PARK or NEUTRAL and the following conditions occur for 10 seconds:
The throttle position (TP) is 5 percent or greater.
Engine torque is greater than 68 N·m (50 lb ft).
The vehicle speed is 32 km/h (20 mph) or greater.
