DMH cutout installed (video inside)
#1
DMH cutout installed (video inside)
I installed a single cutout , had the X piped pushed back closer to the headers and the cutout dumps right out just after the x-pipe on the passager side.
Its a tight fit and sits about a inch lower then then the long tubes. if lowerd it might be an issue but I think its not bad. Its sitting on the passanger side.
I know some guys are going to flame on me my since I only installed one. But on a N/a motor you wont gain any more power with 2 cutouts. As long as its after the X-pipe it will flow both manifolds . Exhaust will flow the path of least resistnace and our cadi also has daul 2.5 pipes as well.
Heres a vid and I did a flyby, but I went to fast in the flyby to realy hear the exhaust lol
http://www.youtube.com/watch?v=I36qvGBxGSo
Its a tight fit and sits about a inch lower then then the long tubes. if lowerd it might be an issue but I think its not bad. Its sitting on the passanger side.
I know some guys are going to flame on me my since I only installed one. But on a N/a motor you wont gain any more power with 2 cutouts. As long as its after the X-pipe it will flow both manifolds . Exhaust will flow the path of least resistnace and our cadi also has daul 2.5 pipes as well.
Heres a vid and I did a flyby, but I went to fast in the flyby to realy hear the exhaust lol
http://www.youtube.com/watch?v=I36qvGBxGSo