lubelizard

iTrader: (5)

There are several Aeroquip/aircraft fitting stores in my area. I need to find out what the dimensions of the LS7/CTS clutch slave bleeder port is, the fitting most places use on the other end, and the length of braided line most of you V drivers like with the remote bleeder. I'll just make one myself and have the store crimp the braided hose for me.

maxspeed96ct

iTrader: (3)

good luck trying to find out, i went to every local hydrolic and fiting store in CT and had no luck.
Was able to match the thread but the fiting has to have a tapperd end aswell.

I hear guys run the LAPD bleeder and it fits.

lubelizard

iTrader: (5)

I doubt the fittings are proprietary. What length hose would you say is ideal for the V? I have to get prices on parts, it may wind up being cheaper to buy a ready made unit.

maxspeed96ct

iTrader: (3)

~ 3ft should be plenty

SkullV

iTrader: (11)

Check in the transmission section here. I asked a while ago about remote bleeders when I thought LAPD wasn't taking orders and the guys there seemed to know the parts needed.

raven154

iTrader: (14)

The fittings are 45* -3

SE-R Spec

iTrader: (2)

I know this is a 6 year old thread but the thread pitch for the ls7 bleeder valve is m8 x 1.25 for the DIY'ers out there making your own speed bleeder.