CTS-V carbon fiber
#101
Restricted User
Thread Starter
Join Date: May 2012
Location: Pennsylvania
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
#102
Comparing a laminate carbon to a new piece made from carbon is also apples to oranges if any one is going to spend money on a carbonfiber part it should be made from carbon fiber not just throw on carbonfiber laminate over existing part
#105
250 seems pretty steep since you are laminating parts we already have.
i thought you would have made the bezel, maybe a custom mount boost guage, etc interior parts from molds etc out of cf.
i thought you would have made the bezel, maybe a custom mount boost guage, etc interior parts from molds etc out of cf.
#108
TECH Addict
iTrader: (19)
Join Date: Aug 2007
Location: Where the Navy tells me to go
Posts: 2,397
Received 106 Likes
on
88 Posts
I would think you'd be much better off going to a dedicated composites forum, like this one, rather than asking in a Cadillac forum where few (if any) people have done what you're asking about.
Last edited by AAIIIC; 07-08-2014 at 12:24 PM.
#109
TECH Addict
iTrader: (10)
I would think you'd be much better going to a dedicated composites forum, like this one, rather than asking in a Cadillac forum where few (if any) people have done what you're asking about.
#111
And if this thread is still somewhat alive then I'd jump in and say this is basically what I would like, but for the V1 instead. Front and side splitters. Perhaps a rear valance of some kind like the AtS-V has.
Such a kit would look killer on the V1 imo.
Such a kit would look killer on the V1 imo.
#112