What did you do to your V today?
#382
TECH Regular
I replaced the wiper motor cover (with the circuit board that attaches to the motor itself).....
Did you paint the cowl cover?
I scored two heavy *** Goodyear LS2 runflats for $15 each, with a buttload of tread remaining. Puttin' em on the rear!!!
Did you paint the cowl cover?
I scored two heavy *** Goodyear LS2 runflats for $15 each, with a buttload of tread remaining. Puttin' em on the rear!!!
Last edited by hefftone; 11-11-2014 at 08:41 PM.
#384
TECH Regular
Something goes bad and the wipers just run all the time. I think its that round white **** looking thing. The new one had a detent, the old one just spun...so I think the wipers are looking for a park position but never find it, so just keep turning.
Its simple to replace except for getting the passenger side wiper arm off... holy crap is it on there!
Its simple to replace except for getting the passenger side wiper arm off... holy crap is it on there!
#389
#392
TECH Regular
Installed my shifter from Domestic V8 Solutions....man what a nice piece. It feels amazingly smooth. Nicely crafted and probably indestructible. If you dont have a shifter yet (maybe I was the last person) you're a damn fool if you dont check this one out.
#395
Replaced my radiator over the weekend. Only had the car for 1,000 miles! I hope this doesn't start a trend. On the plus side, it was almost 50 degrees outside instead of the 15 that it has been, and I just beat the snow that is coming down totay.
#398
Launching!
iTrader: (1)
Join Date: Mar 2004
Location: Smyrna, GA
Posts: 252
Likes: 0
Received 0 Likes
on
0 Posts
Replaced front fe4 shocks last Friday. Made a huge difference but now I am sure I need new sway bar mount bushings because the front end still clunks going over small bumps.
Also discovered what sounds like a stumble in the exhaust note at idle with a slight ticking sound that increases with rpms. Gonna pull valve covers this week to see if I have a bent pushrod somewhere....I hope and not something else.
Also discovered what sounds like a stumble in the exhaust note at idle with a slight ticking sound that increases with rpms. Gonna pull valve covers this week to see if I have a bent pushrod somewhere....I hope and not something else.
#399
TECH Resident
iTrader: (6)
Today I replaced my cracked and non-functioning 3rd brake light, hot glued my LED reverse and license plate bulbs into their sockets, and re-loomed the trunk lid wiring harness. The bulbs had all worked themselves loose because the trunk lid closes so heavy. Didn't have the motivation to get the oil changed in the car, but I did change it in the snow blower. 11" of snow coming tonight, so the car will have to wait until next weekend.