B&M shifter installed
05-17-2008, 12:29 AM
#1
On The Tree
Thread Starter
iTrader: (2)
Join Date: Oct 2007
Location: Dallas, TX
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
B&M shifter installed Installed the B&M shifter today, with UUC bushings. What a pain 
, I didn't remove any of the exhaust or lower the transmission. Took me about 3 hours total. Shifts are soo damn crisp now. It's like magic.
It is a bit noiser then stock, you can feel the extra vibration when you put your hand on the shifter during shifts. Not too bad, overall very happy with it. I will most likely wrap it with a bit of dynamat tomorrow.
The bushings helped as well, my factory ones were a bit squished. New ones removed any lateral shifter slop.
, I didn't remove any of the exhaust or lower the transmission. Took me about 3 hours total. Shifts are soo damn crisp now. It's like magic.It is a bit noiser then stock, you can feel the extra vibration when you put your hand on the shifter during shifts. Not too bad, overall very happy with it. I will most likely wrap it with a bit of dynamat tomorrow.
The bushings helped as well, my factory ones were a bit squished. New ones removed any lateral shifter slop.
Trending Topics
05-19-2008, 06:19 AM
#10
So far it's a world of difference. No slop, very little, and much more precise. Absolutely a must in any V. Install was straight forward and besides a little noise in 2nd I'm very happy.
Went for some spirited driving yesterday after the install...car I finally feel like I have the car I was wanting. :wow: Who thought 4 doors and 4000lbs could move like this?
Went for some spirited driving yesterday after the install...car I finally feel like I have the car I was wanting. :wow: Who thought 4 doors and 4000lbs could move like this?
05-28-2008, 09:09 AM
#12
05-29-2008, 06:17 AM
#14
