I'm looking to buy 6-8 nuts that are exactly the same as the ones that hold on the trunk finish panel that has the reverse lamps.

I has the built in washer that spins. The nut is 10mm and the washer is about 3/4" in diameter.

Let me know what you have

 

I have a dealership....just down the road.

 

You have those where you live, too? Crazy!

 

$6 a nut... (no pun intended). Not a lot of junk yards in CA.

 

I apologize. I meant to say "stealership" I have a stealership down the road from me!

 

If I had 10 nuts weighing down my sack, I'd gladly give you 6-8 of them. At that point though, the things in life I've pledged my left nut for have almost all been valued over $6.

 

My local home depot has some just like those in 10mm

 

did you bust the old ones?

 

I try to bust a nut when and where possible!

 

Probolt alu nuts are cheaper and the same quality

 

Acme and other fastener companies carry the correct coated ones.

 

Comedians!!

 

Was at the junkyard today looking for assorted bits and pieces and picked these up. 3 CTSs there, none of which had the license plate panel still on the trunk. However, I found a couple nuts in one trunk, and the rest in another trunk. Pretty sure the 1 larger diameter one is from the taillight, but it was loose in the trunk with the smaller ones, so I grabbed it, too. Same nut, just a bigger washer.

So, if the dealership wants $6 each, I think I can offer a great discount - only $5 each!! That's 16% off for genuine GM parts!!! Of course, I'll have to give you the GM Parts Direct shipping deal, so tack on 20% for S&H.

Seriously, PM your address and I'll send 'em Priority Mail tomorrow.

 

No longer need nuts?