to ms3 and stock heads or mill heads and get smaller cam?
#1
Teching In
Thread Starter
Join Date: Oct 2011
Location: gautier,ms
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
to ms3 and stock heads or mill heads and get smaller cam?
so I can't decide here, which would be more benificial: to run an ms3 cam with stock spec. heads or get the heads milled about .040 and go with a slightly smaller cam to prevent ptv contact issues
my current setup is a gen III 5.3, flat top pistons and rods from a gen iv, 862 heads, arp rod bolts, lunati springs, victor jr with Holley 750, th350 that will probably getting a 4k stall, the car will be 25/75 street/strip and will more than likely get nitrous later down the road, all suggestions would be greatly appreciated
my current setup is a gen III 5.3, flat top pistons and rods from a gen iv, 862 heads, arp rod bolts, lunati springs, victor jr with Holley 750, th350 that will probably getting a 4k stall, the car will be 25/75 street/strip and will more than likely get nitrous later down the road, all suggestions would be greatly appreciated