bugy

hi, piston seems to be too close to reluctor wheel when crank is going bdc, clearance is less than .010" already milled piston until possible, could i mill reluctor wheel for more clearance? would that be risky? about .010" clearance between piston-reluctor wheel, would that be bad?
one more thing what's the normal distance crank sensor to reluctor wheel?
thanks guys.

ZONES89RS

iTrader: (25)

Get ahold of LME or another engine builder that has done hundreds of builds. They will have the right answer.

S10xGN

iTrader: (11)

From what I hear, the MSD units are already pretty picky about the crank signal, no sense in tempting fate...