lsx-foxbody driveshaft length questions
#1
Staging Lane
Thread Starter
Join Date: Sep 2009
Location: Pittsburgh
Posts: 97
Likes: 0
Received 0 Likes
on
0 Posts
lsx-foxbody driveshaft length questions
I have been reading if you use a th350 with a 9" tailshaft you can reuse the stock mustang driveshaft.
Is this correct?
Is this with the 4.6 K member or the AJE kit? Or both?
I am also under the inpression the 4l60e and 80e are the same length as the above mentioned th350?
I have been searching and searching but noone clarifies what K member and mounts they have used.
Thanks, Steve
Is this correct?
Is this with the 4.6 K member or the AJE kit? Or both?
I am also under the inpression the 4l60e and 80e are the same length as the above mentioned th350?
I have been searching and searching but noone clarifies what K member and mounts they have used.
Thanks, Steve
#2
Launching!
iTrader: (1)
Steve, hopefully these will help you.
Proper way to measure driveshaft.
Transmission Dimensions
Mike
Proper way to measure driveshaft.
Transmission Dimensions
Mike
#3
Staging Lane
Thread Starter
Join Date: Sep 2009
Location: Pittsburgh
Posts: 97
Likes: 0
Received 0 Likes
on
0 Posts
Thank you, now I need to know what K member setup to use with a th350 setup.
It says the 80e is roughly 2 inches longer than a 60e and th350 with the 9inch tailshaft.
It says the 80e is roughly 2 inches longer than a 60e and th350 with the 9inch tailshaft.