Jadedbird

iTrader: (27)

Alrighty so im considering taking my ls1 that i have sitting in my garage and dropping it into a silverado

Now i know the blocks are identical so it should drop in
but i have a few questions

what will i have to do to run a ls6 intake on it?
will the truck throttle body match up with the ls6 intake?
will i have to run ls1 front accessories or can i stick with the truck accessories?
will i have to run a new pcm and engine harness?
regular silverado headers would work right?

and what would need to be done if it was a 4.8L truck?

sorry im new to this and ive tried searching but there are no write ups, only references that ive found

greenturtle05

iTrader: (6)

Check out http://www.ls1truck.com/forums/index.php

Jadedbird

iTrader: (27)

Ill have to check that out indeed

t_raven

iTrader: (12)

I've seen guys use LS6 intakes with truck accessories. Ls1truck has an thread about swapping intakes

http://www.ls1truck.com/forums/front...take-swap.html

Unless you care about the weight savings, since trucks are heavy anyway, you might consider selling the LS1 and buying a 6.0. The difference in value could be used for some mods

Jadedbird

iTrader: (27)

Well i have a 5.7 sitting around with low miles. Ive tried selling but everyone wants me to give it away haha

Smoke23

I was told by Street & Performance the flywheel had to be changed out or the hole need to be egg shaped. I also have a fresh 5.7 short block laying around but people want it given to them as well....

Jadedbird

iTrader: (27)

Could i use my flywheel off the 6.0?