Easy harness question? What to do with this connector to fuse box?
#1
Easy harness question? What to do with this connector to fuse box?
Putting a 99 LR4 in a 75 Mercedes. Using the stock truck harness.
Am I right in my thinking that connecting this to the right stuff and the rest to the engine and pcm will make it run? I think I need to hook up the pink and orange to 12V+ and the black to ground . Then what about the light green, dark green/white, purples, yellow, dark green, dark blue and light blue?
Am I right in my thinking that connecting this to the right stuff and the rest to the engine and pcm will make it run? I think I need to hook up the pink and orange to 12V+ and the black to ground . Then what about the light green, dark green/white, purples, yellow, dark green, dark blue and light blue?
#2
That's part of the factory bulkhead connector that tied the engine compartment harness to the under dash harness. Theres more to it than just "connecting this to the right stuff"- are you removing any of the emissions systems? Making any other mods?
#4
If aren't using the original fuse panel that the connector in your pic plugs into then you won't be usin that connector at all.
Lt1swap.com has a pin out of what wire goes where. You would need to follow the diagram on there and label each wire then cut it from the connector.
Lt1swap.com has a pin out of what wire goes where. You would need to follow the diagram on there and label each wire then cut it from the connector.