wiring inj2
#1
On The Tree
Thread Starter
iTrader: (3)
Join Date: Dec 2005
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
wiring inj2
OK I did the v6 to ls swap. Used engine harness from 01 trans am. Kept fuse box from v6 car runs just throwing po200 code realized inj2 isn't wired up. I have learned its pink wire but where is it lol. Also do iI just give it acc 12volts
#5
TECH Senior Member
iTrader: (12)
I would add to make sure you power the IGN / Pinks wires from a source that has power in both the Run and Start positions of the Ignion switch. Many have encountered issue because the circult cuts out when the key / switch is moved to the Start position.
You could bundle them all together and use a single fuse, but might be a better idea to seperate them into bank #1 and #2 as suggested and like GM has them wired up and fused.
The OEM setup does bundle and route through the Cxxx plugs and to the fuse box and back to the injectors.
BC
You could bundle them all together and use a single fuse, but might be a better idea to seperate them into bank #1 and #2 as suggested and like GM has them wired up and fused.
The OEM setup does bundle and route through the Cxxx plugs and to the fuse box and back to the injectors.
BC
#6
On The Tree
Thread Starter
iTrader: (3)
Join Date: Dec 2005
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the help. I have read that I can just jump the hot wire off the rear o2 since I'm not using it. I was told its on the passenger side on the wheel well also I could find INJ2r there as well. but in all the schematics I've seen I haven't seen INJ2 anywhere