5.3 maf wiring
#1
5.3 maf wiring
so when i bought the engine a the harness, i noticed that the maf plug was missing, so i bought a new maf with a pigtail, my maf has 5 wires, tan, yellow, pink black and blk/wht, but my harness has like 4tan wires and twoblack and two pink wires.... my maf has a iat sensor in it so what are these extra wires for? any ideas?
#5
one of the tan wires is for IAT sensor the others are
25 TAN 1671 HO2S Low Signal - Bank 2 Sensor 2
26 TAN 1667 HO2S Low Signal - Bank 2 Sensor 1
3 TAN 1465 Fuel Pump Relay Control - Secondary (Dual Tanks)
25 TAN 472 IAT Sensor Signal
are 1671 and 1667 some kind of sensors? what do they look like?
25 TAN 1671 HO2S Low Signal - Bank 2 Sensor 2
26 TAN 1667 HO2S Low Signal - Bank 2 Sensor 1
3 TAN 1465 Fuel Pump Relay Control - Secondary (Dual Tanks)
25 TAN 472 IAT Sensor Signal
are 1671 and 1667 some kind of sensors? what do they look like?
#6
yeah, ho2s is your oxygen sensors. there were 4 total, usually the rear 2 are deleted though, in the pcm and also removed from the harness. get a continuity tester and check the pins at the pcm and you'll be able to id all those wires without tracing them all out physically.
#7
Teching In
Join Date: Apr 2013
Location: San Antonio, TX
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Bear with me for a little bit of thread revival...
I'm in a similar situation to the one you were in. I have a MAF, but no pigtail for it and I need to figure out where to wire it into the wiring harness. I can probably figure out the wiring from this thread and some other pinout data I've seen, but I still need a MAF pigtail. Where did you buy yours from and how much did it cost you?
I'm in a similar situation to the one you were in. I have a MAF, but no pigtail for it and I need to figure out where to wire it into the wiring harness. I can probably figure out the wiring from this thread and some other pinout data I've seen, but I still need a MAF pigtail. Where did you buy yours from and how much did it cost you?