Jimbo1367

Looking good. Did switching to DBC solve the problems?

jgh64pkup

I havnt finished the wiring yet. I still need to buy a relay board and get it tuned. I had 2 tires go bad on my truck so Ill have to replace those before i do anything else to the car.

BSmiff

Ready to see that beast hit the strip

jgh64pkup

Me too, Im not real sure what to expect out of it. Hoping for mid to high 6s on spray, mid 7s on motor.

BSmiff

I agree with that. You might be able to push it a touch further on the bottle depending on how you hit it and how much you hit it with.

jgh64pkup

It has a 175 in it now and I have some 225 jets. I can also get ahold of a two stage plate. So I was thinking of running a 175 and a 100, not too sure yet though.

LsxSwapped88

Love the build, doing the same thing on my 95 but turbo instead of nitrous. Sub'd Also sent you a pm

BSmiff

When you hit the track get some video. This thing should be scooting.

jgh64pkup

I havnt worked on the car much but I have gotten a few things done. I relocated the fuse box to the inner fender, and Im still sorting through wiring. I bought another mustang that needed an engine rebuild and a trans, so thats tore apart. I bought it to make money on and its turning into a nightmare.

jgh64pkup

The mustang I bought. 1996 non PI 4.6/ 5 speed. doing a PI swap, centerforce dual friction, ebay longtubes, and a upr short throw.

engine and trans pulled


Short block built.


Im just waiting on a set of heads and Itll be back together.

jgh64pkup

Heres the fuse box tuck on the silver car. and a couple pics with the dash out. I still need to tidy a few things up.

Blown06

iTrader: (32)

Damn, did you have Ray Charles paint that motor? lol

jgh64pkup

Lol I knew someone would notice that. I just didnt give a **** and didnt tape anything off. At least the surface I was painting was clean before I painted it. The LS was taped off before I painted it.

jgh64pkup

Heres a couple of old videos from when I first put it together. This is before I swapped converters.
http://vid886.photobucket.com/albums...artburnout.mp4
http://vid886.photobucket.com/albums...stangtrack.mp4

jgh64pkup

Ive also been working on wiring.

jgh64pkup

BSmiff

Very pro looking wire job sir

jgh64pkup

Thanks man! Im trying to keep it as clean as possible.

ls02newedge

What are you using for a driveshaft?

Blown06

iTrader: (32)

You are cutting off the bearing/seal ends and rewelding them when you're done.........no?

I can almost see the bend in that rear, or is it just the angle of the pics?