flipping the fuel rail question?
Thread Starter
TECH Enthusiast
Joined: Apr 2006
Posts: 630
Likes: 1
From: New York City
flipping the fuel rail question? just to make sure . can I unbolt , unclip and flip the fuel rail, so the feed is on the pass. side on a stock 06 ls2 ? thanks , JOHN
Last edited by john 67; Jan 3, 2009 at 08:01 PM. Reason: mistake
I know that it can be done for sure on the LS1's... I have done this to my setup.. if the LS2 is based on Gen III and IV .. Then I would say that you should be able to flip the fuel rail 180 also....
Post #2, second picture....yes it will work....
https://ls1tech.com/forums/conversio...de-1500-a.html
T,
https://ls1tech.com/forums/conversio...de-1500-a.html
T,
I have flipped it on my LS1.. to put the inlet on the passenger side where my stock location of the hardline is. The FRC would have a problem in there would be no slot / hole for the fuel rail inlet, but nothing you can't fix. Also, your relief valve might be hard to reach.
If you noticed, I did away with the QD by brazing a AN bunt on the end of the Fuel inlet.
If you noticed, I did away with the QD by brazing a AN bunt on the end of the Fuel inlet.
