84 Cutlass lq4 swap pics
#48
Teching In
Join Date: Mar 2010
Location: Hot Springs, Ar
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
curious to know what upper hose you used, and howd you connect your power steering lines to you steering box? the fitting on the passenger side that hoses up to your map?, did you tighten it sll the way or just snug?
#49
#50
Staging Lane
Thread Starter
Join Date: Jan 2008
Location: Quebec in Canada
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
hi bowtie. i speak french so i'll try to explain you the best way I did it. my upper radiator hose is the original one from the truck. the lower one is made with 2 different hoses cutted and attached together with water piping, it takes a little imagination to do this one. as for the power steering lines , i don't remember very well but i used the same lines from the truck or my car but i didn't bought other power steering lines that the ones i had ! and for the hose i think you say, it's the tube that get the air out the system. you can run it to your radiator by welding a brass fitting like i did ! if you have other questions, let me know !!
#54
Staging Lane
Thread Starter
Join Date: Jan 2008
Location: Quebec in Canada
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
hi inbred i painted my engine with a ford (motorcraft) aluminium paint i bought at the dealership . you need to spray a lot of thin layers to have a good result. I didn't primed but i think it would be better.
ls184cutlass, my suspension is a set of eibach pro kit but on the front I cutted half of the first spire because the front was too high, you might have to try it first without cutting !
ls184cutlass, my suspension is a set of eibach pro kit but on the front I cutted half of the first spire because the front was too high, you might have to try it first without cutting !
#56
hi inbred i painted my engine with a ford (motorcraft) aluminium paint i bought at the dealership . you need to spray a lot of thin layers to have a good result. I didn't primed but i think it would be better.
ls184cutlass, my suspension is a set of eibach pro kit but on the front I cutted half of the first spire because the front was too high, you might have to try it first without cutting !
ls184cutlass, my suspension is a set of eibach pro kit but on the front I cutted half of the first spire because the front was too high, you might have to try it first without cutting !
#60
Teching In
Join Date: Apr 2010
Location: NORTH Temperance, MI
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts