726.0chevelle

iTrader: (17)

i did a few searches and can not find any info is the hole that is tapped for the coolant sensor 1/4 npt? i am putting a set of guages in my car today and the sensor that comes with my guages is 1/8 npt so what adapter am i going to have to use to put my sensor in the side of the head thanks

1987earthquake

iTrader: (9)

The hole on the head is 12mm metric. no fitting to adapt to 1/8" npt. But you can take a 3/8" npt tap iirc and tap the 12mm hole to the 3/8" npt. then you can find an adapter for the 3/8 to 1/8. Oh and stick the tap in a can of grease before you tap if you leave the head on the motor.

Pop N Wood

iTrader: (1)

This kit has the M12x1.5 to 1/8 npt adapter you need

http://www.autobarn.net/eqoilpreselt.html

The kit also has the adapter for the oil pressure if you need it. You can find similar kits in other places. Sunpro makes one, as well as others.

Monte_LS3

Or turn your existing sensor down to 12mm and chase the M12 x 1.5 thd. Alternately, run the correct metric die on the sensor. Apparently seals on the straight threads, but a copper crush washer was included.....