Y-Pipe Pressure Test
05-03-2009, 03:59 PM
#1
On The Tree
Thread Starter
iTrader: (4)
Join Date: Mar 2007
Location: San Antonio, TX
Posts: 104
Likes: 0
Received 0 Likes
on
0 Posts
Y-Pipe Pressure Test I am working on an LS1 swap that is going in a 1990 Chevrolet Truck. Slow process but I am getting there.
I just finished my homemade y-pipe and pressure tested it. I sealed up all 3 ends and put about 25 psi into it. Then I sprayed soapy water on all the welds. I got a couple of places where it had leaks, they were real small and hardly noticeable, but were there. My question is this. Is it alright to use it? I plan on getting it powder coated soon. Thanks Art...
I just finished my homemade y-pipe and pressure tested it. I sealed up all 3 ends and put about 25 psi into it. Then I sprayed soapy water on all the welds. I got a couple of places where it had leaks, they were real small and hardly noticeable, but were there. My question is this. Is it alright to use it? I plan on getting it powder coated soon. Thanks Art...
