383lt1impala

iTrader: (33)

Sweet project!!!! And I guess im not the only one using the manifolds flipped upside down.

383lt1impala

iTrader: (33)

Btw won't the spark wires won't burn with them right on the manifolds?

lyle7212

you sure don't waste any time...

chevellepowered

iTrader: (37)

yea i have had problems with the spark plug wire's.. i did wrap them and the exhaust.. but they still get hot and i dont like it at all. . i might do something diffrent,, i really want to build my own turbo header manifolds.like the truck set up. on that 89 truck i think,, serria ,same build basically.. use a shorty header on one side driver side. ,going into the other side exhaust log setup..

yea i dont waste time, if i had the money/funds it would be done already a while ago..

still gota buy 4l80e manual valve body and blowthru carb.and do exhaust..

placing this turbo in my car is really got me stressed out, how to do the piping, were to put it.etc... were to route down pipe.. .. . i will probly just take it to a local shop in ocala.it will have the ugly bends in it ,but it will work. probly cost less than $150







here's my new thread i started.. a big ole ly6 ,,6.0 with l92 heads..https://ls1tech.com/forums/conversio...ly6-4l80e.html

383lt1impala

iTrader: (33)

Yea I feel u on that. I only worked a few hours last month and before that I havnt worked in 11 months! Its been about 9 months since I started my impala project if this was 2007 or earlier it would have been done 8 months ago. But good luck on the rest of the build. ill keep checking up on this thread!