msd 6010 mounting ideas??
#1
msd 6010 mounting ideas??
where is everyone mounting there msd boxes? i was thinking of mounting it in the car under the dash but i'm not sure the harness is long enough... i'd like to see some pics....
#2
TECH Fanatic
iTrader: (23)
I put mine in the kick panel of my camaro inside the car. Then ran the serial port up the center console and into the CD holder area. Totally stealth but easy to change set points. If you drill a hole under your heater box area you have plenty of wire length if you take your time.
#4
as lone as the harness is long enough i'll be good then!
71 chevy this is what i am planning on to get by the big hole....
http://www.summitracing.com/parts/SIT-SGS3-5-100/
71 chevy this is what i am planning on to get by the big hole....
http://www.summitracing.com/parts/SIT-SGS3-5-100/
Trending Topics
#17
I machined a two piece bulkhead and attached it with some stainless hardware. I mounted the box inside under the dash and routed the harness through a hole slightly larger than the largest connector.