Edelbrock 2nd gen Camaro LS1 Headers installed with pics
#1
TECH Fanatic
Thread Starter
iTrader: (16)
Join Date: Dec 2004
Location: Jefferson, Ga
Posts: 1,182
Likes: 0
Received 0 Likes
on
0 Posts
Edelbrock 2nd gen Camaro LS1 Headers installed with pics
So after looking for a long time for headers for my 77 TA I finally found that Edelbrock has headers for the 2nd gen f-body LS1. They say you have to use their motor mounts but I have the 1st design BRP kit. The headers fit great with plenty of clearance all around. at $519 stainless coated no complaints here.
1968-72 GM A-Body, 1970-81 GM F-Body and 1975-79 X-Body with LS Series V8 conversion headers (1-3/4", stepped to 1-7/8", 3-1/2" collector) #65073
1968-72 GM A-Body, 1970-81 GM F-Body and 1975-79 X-Body with LS Series V8 conversion headers (1-3/4", stepped to 1-7/8", 3-1/2" collector) #65073
#4
Looking good man! I did this swap a while back but used BRP's kit...what a CF!!!
Their headers don't fit for ****!!! I had to trim a lot to get the kit to fit and since my car is heavily lowered it doesn't give me ANY ground clearance.
I was wondering what pan you used and did you lower your car at all?
Thanks!
Dave
Their headers don't fit for ****!!! I had to trim a lot to get the kit to fit and since my car is heavily lowered it doesn't give me ANY ground clearance.
I was wondering what pan you used and did you lower your car at all?
Thanks!
Dave
#5
TECH Fanatic
Thread Starter
iTrader: (16)
Join Date: Dec 2004
Location: Jefferson, Ga
Posts: 1,182
Likes: 0
Received 0 Likes
on
0 Posts
Looking good man! I did this swap a while back but used BRP's kit...what a CF!!!
Their headers don't fit for ****!!! I had to trim a lot to get the kit to fit and since my car is heavily lowered it doesn't give me ANY ground clearance.
I was wondering what pan you used and did you lower your car at all?
Thanks!
Dave
Their headers don't fit for ****!!! I had to trim a lot to get the kit to fit and since my car is heavily lowered it doesn't give me ANY ground clearance.
I was wondering what pan you used and did you lower your car at all?
Thanks!
Dave
#6
Launching!
Great looking project. Who makes the fuel injection setup that you are using? I am looking at running the same type of system. Is this a kit from one company or is it a combination of many different manufacturers?